Shenzhen Huayatai Packing machinery Equipment CO.,Ltd

Specializes in the research and development of packaging machinery manufacturers.

Home > News > Content
Shrink Film Packaging Machine In The Use Of The Precautions
- Jul 11, 2017 -

  Shrink film packaging machine in the use of the precautions

  With the current shrinkage class packaging equipment has been widely used, the daily use of our shrinking film packaging machine should be used in the attention and understanding of the matter, not only can play a role in the protection of human safety But also to avoid possible operational errors happen.

  Heat shrinkable film packaging machine use precautions

  First, the shrinking film packaging machine power is relatively large, in daily use need to pay attention to is in the wiring, please ensure that the power supply power must be greater than the nominal power of the shrink machine, or easy to burn the line or machine.

  Second, the shrinking film packaging machine must be reliably grounded, brush the ground with an insulating paint to lead a bottom line to protect the safety of the person.

  Third, the shrinking packaging machine factory has a power cable connected to the end of the lead part of the power with the identification of the symbol, but also please use the correct use of the process if you do not understand the problem suggested that the telephone consultation My company or look at the machine to send the equipment manual. All illegal operations are likely to result in the burnout of the machine or the occurrence of electric shock.

  Fourth, when the machine specified voltage for the three-phase 380V power supply, you must also access the zero line, the standard three-phase four-wire system. Otherwise the machine can not work properly, and can easily burn the internal electrical parts.

  Fifth, the shrinking machine must be installed horizontally, otherwise it will shorten the life of the heating tube; for the belt drive machine, the tilt installation will lead to the conveyor belt away from the center, greatly reducing the service life.

  Sixth, the machine for more than three months of continuous use, should be contaminated room high temperature line to check, according to its aging, as appropriate replacement.

  Seventh, the machine work, the operator's palm and other parts are not allowed to contact with the operation of the machine parts, especially the internal temperature of the shrink room is very high, it is easy to burn.

  Eighth, after the end of the packaging work, should first turn off the heat shrink machine heating switch, so that the transmission motor and fan motor to run for about 10 minutes, and then cut off the entire power supply.